Graupner Pistol grip RC 2.4 GHz No. of channels: 3 94004 Manuale Utente

37                                           94004 GM-Racing XG-6i 2.0 FHSS Race Spec

English

Please start the motor or the engine while making the adjustment of these settings.
1 .  Connect the receiver, servos, and other components and then turn on the power switches
 

to transmitter and receiver.

2.  Be sure the Steering trim and Throttle trim on the transmitter are at their neutral position.
3.  When turning on the transmitter, please make sure the transmitter antenna is completely
 

extended. Turn on the transmitter before turning on the receiver, while turn off the receiver

 

before turning off the transmitter.

Steering Trim (ST.TRIM):
Steering neutral adjustments can be made by moving the steering trim knob to the left or the 
right.
Racers Tip:
Always check and be sure the servo is at its neutral position before installing a ser

vo. Adjust 

the servo horn hole position and linkage so both are parallel. When a servo saver is used, 
place it as closer to center position as possible. Be sure the steering trim on the transmitter at 
the neutral position.

Use the timer by selecting one of the two timers UP TIMER and DOWN TIMER, and if the 
MODE is INH, It will close the TIMER Function.
1.  Press “ENTER” to see FUNCTION MENU
2.  Use the +/- Keys to select the TIMER function and press “ENTER”.
3.  Press ENTER to select a item.
4.  Use the +/- Keys to change the value
5.  Press “EXIT” twice to save and return to FUNCTION MENU, press “EXIT” again to return
 

to the Main Screen

Press “ENTER”  to select the MODE. Use +/- Keys to select UP_T. (UP TIMER).

• 

The UP TIMER can be used to count the time from 0 minute 0 second to the stop time. The

• 
 

stop time is set form from 0 minute 0 second to 99 minute 30 second.
The fi rst start operation will be linked to the throttle trigger.

• 

The passage of time is announced by sounding of a buzzer each minute after starting.

• 

The buzzer will sound ‚B-B-B…‘ when the timer is up to the stop time.

• 

Press “ENTER” to select the MODE. Use +/- Keys to select DN_T.(DOWN TIMER).

• 

The DOWN TIMER can be used to count the time from preset time 0 minute 0 second. The

• 
 

preset time is set form  0 minute 0 second to 99 minute 30 second.
The fi rst start operation will be linked to the throttle trigger.

• 

The passage of time is announced by sounding of a buzzer each minute after starting.

• 

The buzzer will sound ‚B-B-B…‘ when the timer is down to the 0 minute 0 second

• 

.