Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Scheda Tecnica

The Linkage Menu is made up of functions 

which  perform  model  addition,  model  type 

selection, system type, end point setting, and other 

model basic settings.

The functions which can be selected depend on 

the model type. A typical menu screen is shown 

below.

*The display screen is an example. The 

screen depends on the model type.

[SERVO]: Displays the servo test and operation position
[MODEL SEL]: Model addition, call, deletion, copy, model name setting
[MODEL TYPE]: Model type, wing type, swash type, etc. selection
[SYSTEM]: System mode selection, link of a transmitter and receiver, area mode selection
[FUNCTION]: Channel assignment of each function can be changed
[SUB-TRIM]: Adjusts the neutral position of each servo
[REVERSE]: Reverses the servo travel direction
[FAIL SAFE]: Fail safe function and battery fail safe function setting
[END POINT]: Servo travel adjustment and limit setting
[SERVO SPEED]:  Speed setup of a servo
[THR CUT]: Stops the engine safely and easily (airplane and helicopter only)
[IDLE DOWN]: Lowers the idle speed of the engine (airplane only)
[SWASH RING]: Limits the swash plate travel to within a fixed range. (helicopter only)
[SWASH]: Swash AFR and linkage correction function (helicopter only)
[T1-T4 SET.]: Control step amount and mode selection of the digital trim
[WARNING]: Mixing warning normal reset 
[TELEMETRY]: Displays various data sent from the receiver.
[SENSOR]: Various telemetry sensors setting
[DATA RESET]: Model memory set data reset

● Access the Linkage menu shown below by 

tapping the LNK button two times.

● Select the function name 

and return to the Linkage 

menu  by  touching  the 

RTN button.　Or a HOME/

EXIT button is pushed.

● Select the function you want to set and call 

the setup screen by touching the RTN button. 

●Calling setup screen

Scrolling

● Moving cursor