Autodesk Inventor Simulation Suite 2008, Crossupgrade from Inventor Series 10, 1 user or network, German 46602-121462-9336 Manuale Utente

7 

Save time by removing the guesswork from part 
design. Examine how parts perform in the real 
world by visualizing how they will deform and how 
much they will deflect.

The stress analysis tools are 

fully integrated with the 

dynamic simulation tools, 

allowing users to perform 

stress analysis with 

accurate load conditions 

that are calculated directly 

from the dynamic behavior 

of the design.

Save money by choosing the best possible material 
type for the task at hand. Using less material 
results in a lower cost per part and saves money 
downstream on shipping, material handling, and 
warehousing fees. 

Make design decisions based on analysis rather than 
intuition. Let the simulation assist in building the 
optimal part. Visually identify trouble spots that 
fall below safety factor requirements and develop 
alternative solutions for these areas.

The stress analysis functionality in Inventor helps users 

understand how parts perform under load, so they know their 

designs have sufficient strength to perform without failure.  

Stress Analysis

Execute Stress and Strain Analysis directly in 
Inventor, with technology powered by ANSYS

®

 

DesignSpace. Embedded analysis types are 
displacement, safety factor, and stress, including 
maximum and minimum principal stresses.

Analyze the stress in a moving part at different 

points in the mechanism’s operating cycle. Import 
loads from multiple steps in a dynamic simulation, 
then calculate and view the resulting stresses in a 
single analysis run.