Renkforce 1243795 Wireless Surveillance System 1243795 Scheda Tecnica

  “Start Time” 

Time for recording start (hours/minutes)

  “End Time” 

Time for recording end (hours/minutes)

•  Save the selection with the button “OK” (8); then you will leave setting mode again. Cancel as usual with 

the “MENU” (5) button.

Delete time window
•  Select one of the time windows set up by you with the control buttons “S” or “F” (9); it is highlighted in 

colour.

•  Briefly push the “AV” (7) button to delete the selected time window.

The screen/DVR records the camera image only when a motion is recognised in the recording area. The 

sensitivity of motion detection can be set in 3 stages.
•  After calling the function, you can separately activate the recording/motion detection for each of the four 

possible radio cameras (one is enclosed, up to three more can be ordered as accessories).

•  Select the desired radio camera (channel) with the control buttons “S” or “F” (9); it is highlighted in 

colour.

•  Briefly push the “OK” (8) button to open the setting menu.
•  Use the control buttons “S” or “F” (9) to switch between the different setting options and to change the 

values with the control buttons “G” or “

►” (9).

  “Sensitivity” 

 Set the sensitivity of motion detection (“High”, “Medium”, “Low”).

   

 The higher the sensitivity is set, the smaller changes in the camera screen will 

be sufficient to start the recording.

  “Motion Detection” 

 With  the  motion  detection  switched  on  (“On”),  the  screen/DVR  records  the 

camera image when changes are found in the camera image (e.g. if a person 

enters the recording area).

   

To switch off the motion detection, set “Off”.

  “Stop Condition” 

 Set the time here (8....120 seconds) for which the recording will continue after 

no motion is detected in the recording area anymore. 

  “Area Setting” 

 Here, you can choose the area of the camera image to be used for motion de-

tection. 

   

 When the setting option “Area 

►” is chosen, push the button “OK” (8) to start 

selection of the monitoring area.

   

 Move a star icon (*) with the four control buttons “S”, “F”, “G”and “

►” (9). 

Push the “OK” (8) button to switch the area on or off. 

   

 If the area is on, a “V” appears in the LC display. This area is then used for mo-

tion detection.

   

Use the “MENU” (5) button to save the setting.