Renkforce Wireless Surveillance Kit808578 Resolution (TVL) 420 TVL 808578 Scheda Tecnica

After starting the OSD menu with „MENU/ESC on the DVR or the button „MENU“ on the IR remote control“, 

four different submenus/functions can be selected („Camera Setup“, „Record Setup“, „System Setup“ and 

„Play Back“) that are described in the next section.

In the OSD menu, use the buttons „4“ and „6“ to choose the submenu „Camera Setup“ and then push the 

button „PLAY/ENTER“ on the DVR or the button „

“ on the IR remote control.

Function „Activation“
Unused channels can be switched off here, e.g. when using only two radio cameras/channels (the DVR 

permits use of up to four radio cameras/channels). In single-quad or auto mode (see chapter 10. d), the 

deactivated channels are not displayed. 
Proceed as follows:
•  Use the buttons „4“ and „6“ to choose the submenu „Activation“ and then push the button „PLAY/

ENTER“ on the DVR or the button „

“ on the IR remote control.

•  Use the buttons „8“ and „2“ to select one of the four channels („CAM1“, „CAM2“, „CAM3“ or „CAM4“;

it is marked yellow each.

•  Push the button „PLAY/ENTER“ on the DVR or „

“ on the IR remote control to make the mark switch 

from yellow to red.

•  Switch the channel on or off with the buttons „4“ and „6“ („ON“ = switched on, „OFF“ = switched

off).

•  Confirm selection with the button „PLAY/ENTER“ on the DVR or the button „“ on the IR remote control.
•  Push the button „MENU/ESC“ on the DVR or the button „MENU“ on the IR remote control repeatedly to

return to the respective previous menu or leave the OSD menu.

Function „Brightness“
In this function, the screen brightness for each radio camera/channel can be set separately. 
Proceed as follows:
•  Use the buttons „4“ and „6“ to choose the submenu „Brightness“ and then push the button „PLAY/

ENTER“ on the DVR or the button „

“ on the IR remote control.

•  Use the buttons „4“ and „6“ to pick one of the four channels now.
•  Push the button „PLAY/ENTER“ on the DVR or „

“ on the IR remote control to display the camera 

image of the respective channel.

•  Set the desired brightness with the buttons „4“ and „6“.
•  Push the button „MENU/ESC“ on the DVR or the button „MENU“ on the IR remote control repeatedly to

return to the respective previous menu or leave the OSD menu.