Lecroy WAVEACE 2034 4-channel oscilloscope, Digital Storage oscilloscope, WaveAce 2034 Manuale Utente
Codici prodotto
WaveAce 2034
WaveAce Remote Control
2
920836 Rev A
Remote Control Through USB
The USB interface is standard on every WaveAce oscilloscope. The rear panel USB port is the
remote control interface.
remote control interface.
1. Attach a USB A/B cable from the USB-B port on the rear panel of the scope to a USB-A port
on the controller computer.
2. Install NI-VISA on the controller machine. NI-VISA contains the USB drivers needed to form
the interface between the oscilloscope and the controller. NI-VISA can be downloaded free
from
from
. You may use either the NI-VISA run-time or the full download. The
run-time download is significantly smaller.
You can send remote commands to the oscilloscope directly from the WaveStudio® terminal.
WaveStudio can be downloaded free at www.teledynelecroy.com/support/softwaredownload,
under Oscilloscope Downloads -> Oscilloscope Software Utilities.
WaveStudio can be downloaded free at www.teledynelecroy.com/support/softwaredownload,
under Oscilloscope Downloads -> Oscilloscope Software Utilities.