Carson Pistol grip RC 2.4 GHz No. of channels: 3 500500035 Manuale Utente
Codici prodotto
500500035
30
GB
CARSON Reflex Wheel Pro 50 050 0034 + 35 + 36 + 37
Many publications say that the setup sequence
for the transmitter and receiver don’t play a role
anymore with 2.4 GHz sets. However, we recom-
mend sticking to the sequence typical for previous
sets.
for the transmitter and receiver don’t play a role
anymore with 2.4 GHz sets. However, we recom-
mend sticking to the sequence typical for previous
sets.
• Before operation: First turn on the transmitter,
then the receiver. Lastly, connect the drive bat-
tery to the control unit.
tery to the control unit.
• After operation: Disconnect the battery from the
control unit. Turn the receiver off, and then the
transmitter.
transmitter.
• Before and after operating the transmitter, make
sure that trim is in the desired place and that all
checks have been made.
checks have been made.
BEC receiver:
Battery eliminator is installed in the receiver
circuitry. The receiver gets supplied with current
through the drive battery that runs the engine.
NiMH battery from 6 V to 8.4 V can be used for
circuitry. The receiver gets supplied with current
through the drive battery that runs the engine.
NiMH battery from 6 V to 8.4 V can be used for
the receiver. Batteries of higher voltage may
damage the receiver and servos.
damage the receiver and servos.
Use only a speed controller which has the exclusive
connector for the BEC system.
connector for the BEC system.
Connector motor
Connector battery
Power switch On-/Off
Steering servo
channel 1
(not included)
channel 1
(not included)
Receiver
Do not connect a separate power
supply to the receiver!
Do not connect a separate power
supply to the receiver!
Electronic speed controller
(not included)
(not included)
ATTENTION
Make sure that male and female connectors
have the correct polarity!
have the correct polarity!
Operating Procedure
BEC-System/Connections to Receiver
Version Reflex Wheel Pro2 + Reflex Wheel Pro2 LCD