Intel E3815 FH8065301567411 Scheda Tecnica
Codici prodotto
FH8065301567411
MIPI-Camera Serial Interface (CSI) and ISP
Intel
®
Atom™ Processor E3800 Product Family
1038
Datasheet
Table 174. CSI Signals
Signal Name
Direction
Plat. Power
Description
MCSI1_CLKP/N
I
V1P24S
Clock Lane: MIPI CSI input clock lane 0 for port 1.
MCSI1_DP/N[3:0]
I
V1P24S
Data Lanes: Four MIPI CSI Data Lanes (0-3) for port
1. Lanes 2 and 3 can optionally used as data lanes for
port 3.
1. Lanes 2 and 3 can optionally used as data lanes for
port 3.
MCSI2_CLKP/N
I
V1P24S
Clock Lane: MIPI CSI input clock lane 0 for port 2.
MCSI2_DP/N[0]
I
V1P24S
Data Lane: Single MIPI CSI Data Lanes for port 2.
MCSI3_CLKP/N
I
V1P24S
Clock Lane: MIPI CSI input clock lane 0 for port
3.
3.
MCSI_RCOMP
I/O
Resistor Compensation: This is for pre-driver
slew rate compensation for the MIPI CSI
Interface. Contact your Intel representative for
details.
slew rate compensation for the MIPI CSI
Interface. Contact your Intel representative for
details.
Table 175. GPIO Signals (Sheet 1 of 2)
Signal Name
Direction
Plat. Power
Description
MCSI_GPIO[00]
I/O
V1P8S
Output from shutter switch when its pressed halfway.
This switch state is used to trigger the Auto focus LED for
Xenon Flash or Torch mode for LED Flash
This switch state is used to trigger the Auto focus LED for
Xenon Flash or Torch mode for LED Flash
MCSI_GPIO[01]
I/O
V1P8S
Output from shutter switch when its pressed full way.
This switch state is used to trigger Xenon flash or LED
Flash
This switch state is used to trigger Xenon flash or LED
Flash
MCSI_GPIO[02]
I/O
V1P8S
Active high control signal to Xenon Flash to start charging
the Capacitor
the Capacitor
MCSI_GPIO[03]
I/O
V1P8S
Active low output from Xenon Flash to indicate that the
capacitor is fully charged and is ready to be triggered
capacitor is fully charged and is ready to be triggered
MCSI_GPIO[04]
I/O
V1P8S
Active high Xenon Flash trigger / Enables Torch Mode on
LED Flash IC
LED Flash IC
MCSI_GPIO[05]
I/O
V1P8S
Enables Red Eye Reduction LED for Xenon / Triggers
STROBE on LED Flash IC /
STROBE on LED Flash IC /
MCSI_GPIO[06]
I/O
V1P8S
Camera Sensor 0 Strobe Output to SoC to indicate
beginning of capture / Active high signal to still camera to
power down the device.
beginning of capture / Active high signal to still camera to
power down the device.
MCSI_GPIO[07]
I/O
V1P8S
Camera Sensor 1 Strobe Output to SoC to indicate
beginning of capture / Active high signal to still camera to
power down the device.
beginning of capture / Active high signal to still camera to
power down the device.