Silex Technology Server SX-500-1402 Manuale Utente
Appendix B
Console Commands
The following tables describe the console commands available from the internal command console.
Access the command console through the serial port (if enabled for console mode) or over the network
using a Telnet session or a web browser. The console can also be accessed via UART level signals on
connector CN5 on the Serial Device Server printed circuit board (this requires you to open the Serial
Device Server enclosure and use a special cable and adapter board; it should only be used by qualified
Silex personnel for diagnostic and troubleshooting purposes).
Access the command console through the serial port (if enabled for console mode) or over the network
using a Telnet session or a web browser. The console can also be accessed via UART level signals on
connector CN5 on the Serial Device Server printed circuit board (this requires you to open the Serial
Device Server enclosure and use a special cable and adapter board; it should only be used by qualified
Silex personnel for diagnostic and troubleshooting purposes).
Wireless and Network Security Commands
The following group of commands configures network parameters.
Table 11 Network Commands
Command
Description
SH NW
Displays summary network information
Sample output:
WiFi Mode = INFRASTRUCTURE
WiFi SSID: silex
Speed = 11
Regulatory Domain = 704
WiFi FW Ver = 1F 1.7.1
AP density = LOW
TTLS is Disabled
WEP is Disabled
Link DOWN
WiFi SSID: silex
Speed = 11
Regulatory Domain = 704
WiFi FW Ver = 1F 1.7.1
AP density = LOW
TTLS is Disabled
WEP is Disabled
Link DOWN
SH NW SQ
Display wireless network signal quality
Sample Output::
Signal Quality = 93
Signal Strength = 53
Noise Level = 135
Console Commands
Silex
Page 40
Part Number 140-00188-210A