Garmin 190-01554-00_0C Manuale Utente

If the dog continues barking while wearing the device, you can 

try any of these options to improve the effectiveness of the 

device.
• Tighten the collar until it is very snug (

).

• Adjust the position of the device on the dog's neck (

• Wiggle the device to work the contact points through the 

dog's coat.

• Gradually increase the intensity level (

).

Battery type

User-replaceable 3V CR2 lithium 
cylindrical

Battery life

6 months, typical use

Operating temperature 
range

From 5° to 140°F (from -15° to 60°C)

Water resistance

IPX7

Battery type

Rechargeable, replaceable lithium-ion

Battery life

3 months, typical use

Operating temperature range

From 5° to 140°F (from -15° to 60°C)

Charging temperature range

From 32° to 104°F (from 0° to 40°C)

Storage temperature range (up 
to 1 month)

From -4° to 122°F (from -20° to 50°C)

Storage temperature range (up 
to 3 months)

From -4° to 104°F (from -20° to 40°C)

Storage temperature range (up 
to 1 year)

From -4° to 68°F (from -20° to 20°C)

Water resistance

IPX7

To conserve battery life, the device goes into sleep mode when 

no barks or motion are detected. The activity level of your dog 

affects the battery life of the device.

Rotate the dial away from N.

The color of the status LED indicates the battery charge level 

for five seconds.

Green The battery has a good charge.
Yellow The battery should be charged or replaced soon.
Red

The battery should be charged or replaced immediately. Bark 
correction features are disabled.

Do not use a sharp object to remove batteries.

Contact your local waste disposal department to properly 

recycle the batteries.

À

Back plate

Á

Gasket

Â

Battery

Ã

Polarity indicators

Before you replace the battery, you must remove all dirt, water, 

and debris from the device. You also need a small Phillips 

screwdriver.
You must replace the battery with a 3V CR2 lithium battery.

Remove the four screws from the corners of the back plate.

Remove the back plate.
The battery comes out with the back plate.

Remove the battery.

Install the new battery into the back plate according to the 

polarity indicators engraved on the back plate.
When properly installed, the battery snaps into the back 

plate.

Verify that the gasket is not damaged and that it is 

completely seated in the groove.

Replace the back plate.

Replace the four screws to secure the back plate.

This product contains a lithium-ion battery. To prevent the 

possibility of personal injury or product damage caused by 

battery exposure to extreme heat, store the device out of direct 

sunlight.
Do not use a sharp object to remove batteries.

Contact your local waste disposal department to properly 

recycle the batteries.

Device Information

3