Inter-Tel CS-5400 Manuale Utente

Page  28

Station Programming

  2.

If a password is required, the display shows ENTER PASSWORD. Use the dialpad to
enter your 1–8 digit password and press 

. (If you enter an incorrect password or do

not press 

, the display shows INVALID PASSWORD.)

If a password is not required, skip this step.

  3.

The display shows ENTER DATABASE OPTION. (Display phones also show the
options: ENDPOINT, SYSTEM, and TRUNK.) Press 

 or the 

 menu but-

ton. 

  4.

The display shows ENTER ENDPOINT EXTENSION. Enter the extension number of
the phone to be programmed using one of the following methods. (If you enter an
invalid extension number, you hear reorder tones and must try again.)

Enter a complete number: Enter the extension number using your dialpad. When the
circuit information is displayed, press 

 again to continue.

Enter a partial number: Enter a partial extension number, then press 

, the high end

of the Volume button, or the 

 menu button. The display shows the extension

number, username and circuit number of the phone that most closely matches the partial
extension number. Press 

 or 

 to program the displayed phone, or scroll to

another phone as described below.

Scroll through the numbers: To scroll through the extension number list, press the
high end of the Volume button or 

 to scroll forward, or press the low end of the

Volume button or 

 to scroll backward. When the desired extension number

is displayed, press 

 or 

 to continue.

  5.

The display shows ENTER ENDPOINT OPTION. Select one of the following:

a.

Endpoint Flags: This option allows you to set the Administrator phone, Attendant,
and House Phone flags. To select it, press 

 or the 

 menu but-

ton. Three flags can be programmed: Administrator, Attendant, and House Phone.
However, you cannot program the Administrator flag for your own phone or for a
single line phone. To program the flags, do the following:

1.) To scroll to the desired flag: Press the high end of the Volume button or

 to scroll forward, or press the low end of the Volume button or 

 to scroll backward. 

2.) To enable or disable a displayed flag: Press 

 or the 

 menu button to

enable the flag. Or, press 

 or the OFF menu button to disable the flag.

3.) To save your programming when all flags are set correctly: Press  

or

 to save the new flag settings. The display shows DATABASE

UPDATED and then returns to the ENTER ENDPOINT OPTION prompt.

4.) To exit without saving your changes: Press  

or 

 to exit. The dis-

play shows NO UPDATE PERFORMED and then returns to the ENTER
ENDPOINT OPTION prompt.