Wayne-Dalton TORSION SPRING 9800 Manuale Utente

Please Do Not Return This Product To The store. Call us Directly! Our trained technicians Will answer your questions and/or Ship any Parts 

you May Need. you can reach us toll free at 

1-888-827-3667 for Consumer assistance or online at www.wayne-dalton.com

tools Needed:

IMPORTANT: REaD INStRuCtIONS tItlED “P4” “REMOVING thE OlD DOOR” ON PaGE 9 aND “P5” “PREPaRING thE OPENING” ON 
PaGE 10 bEfORE attEMPtING DOOR INStallatION.

IMPORTANT: StaINlESS StEEl OR Pt 2000 COatED laG SCREWS MuSt bE uSED WhEN INStallING CENtER bEaRING bRaCkEtS, 
END bRaCkEtS, jaMb bRaCkEtS, OPERatOR MOuNtING/SuPPORt bRaCkEtS aND DISCONNECt bRaCkEtS ON tREatED luMbER 
(PRESERVatIVE-tREatED). StaINlESS StEEl laG SCREWS aRE NOt NECESSaRy WhEN INStallING PRODuCtS ON uNtREatED 
luMbER.

NOTE: It is recommended that 5/16” x 2” lag screws be pilot drilled using a 3/16” drill bit, and 1/4” x 2” lag screws and 1/4” x 1-1/2” 
lag screws be pilot drilled using a 1/8” drill bit, prior to fastening. 

None

hand tighten the flagangle to the 
vertical track using (2) 1/4”- 20 x 5/8” 
carriage bolts and (2) 1/4”- 20 flange 
hex nuts. Secure the flange nuts after 
flagangle spacing is complete (Step 9).

(2) 1/4”- 20 x 5/8” 

CaRRIaGE bOltS

(2) 1/4”- 20 

flaNGE hEx NutS

fully 

aDjuStablE 

flaGaNGlE

VERtICal 

tRaCk