Bissell SpotBot Pet 33N8T Manuale Proprietario

Pagina di 12
6. To suction up the dirt and cleaning solution, 
position the suction nozzle over the cleaned 
area, apply downward pressure on the tool,  
and pull nozzle toward you. You should see the 
dirty solution pass through the nozzle. Continue 
until no more solution can be removed. 
notE: In manual mode, the Spotbot is 
equipped with a safety feature which will shut 
the unit off after 30 minutes. press start to 
resume cleaning.
7. 
if the stain is still visible, repeat steps 4-6 as 
necessary.
8. When the cleaning is complete, lightly drag 
the suction nozzle across the stain to further aid 
in drying the cleaned area.
9. before turning off the spotbot, suction up 
clean water to thoroughly rinse out the inside of 
the vacuum flex hose. Then, lift the vacuum flex 
hose upwards to drain any remaining water into 
the dirty tank.
10. Press the Stop button to turn off the 
machine.
11. Disconnect the cleaning tool from the vacuum 
flex hose by pushing down on the button lock 
and pulling straight off (do not twist tools to 
remove them).
12. Unplug the machine and wrap the cord 
around the cord wraps. Attach the Tough stain 
brush to the base of machine. Wrap the hose 
around the machine. 
Storage
1. Press the Stop button to turn the unit off. 
Unplug the power cord from the outlet. Wrap 
power cord around the cord wrap.  
2. empty and rinse the dirty water/collection 
tank after each use, or when dirty water reaches 
the indicated maximum fill line. To remove the 
tank, lift up the dirty tank latch and pull the tank 
out. Dump out the dirty water and rinse. Replace 
the tank into the unit for storage. After using the 
spotbot’s automated feature, wipe the window 
and brushing area with a soft cloth.
3. if you were using your spotbot manually, wrap 
the vacuum flex hose around the unit and secure 
the hose into the hose connector on the front of 
the unit.
4. store unit indoors at room temperature  
(40° to 110°F).
www.bissell.com   
   800.237.7691
8
2.
3.
11.
Operations
WaRnInG
To reduce the risk of electric shock, turn power switch  
off and disconnect plug from electrical outlet before 
performing maintenance or troubleshooting checks.
»  If a significant amount of water and solution 
remains in the clean tank, your unit can be 
stored with liquid in the clean tank. However, 
if you have added OXYgen Boost into the clean 
tank, it cannot be stored in the the unit and 
should be flushed.
»  Clean out the black valve periodically inside of 
the dirty water/collection tank.
Tips