AMANO PIX-3000XNT - Enterprise Solution Guida Al Funzionamento

PIX-3000x Operations Manual 

29 

To prevent damage to the PIX-3000x, it is recommended to only use 
paper type media. Special care should be taken to avoid inserting paper 
with staples, paper clips, or other fastening devices directly under the 
print frame as damage can occur. Care should also be taken when 
inserting paper and removing paper from the PIX. Upon inserting, make 
sure the paper does not bend or crumple, because it may jam the 
machine. Before attempting to remove the paper you should wait until 
the unit has completed its print cycle. The PIX secures the paper by 
clamping down on it, so if you attempt to remove the paper too soon it 
may tear inside the machine. It is recommended to periodically clean the 
inside of the machine. This is accomplished by using a can of 
pressurized air to blow out paper dust. A good time to perform this 
preventative maintenance is when you are changing the print ribbon.  
 

If AC power is connected and good, the display colon will “Blink.” Upon 
loss of AC power, the display colon will remain constantly visible. 
 

In the event of an error, a message will appear in the display. The 
available messages are listed below along with their possible causes and 
solutions.