Znyx Networks ZX4300P Manuale Utente

The ZX4300P is an unmanaged layer 2 switch requiring no software setup or configuration. Once 
the switch is installed in a chassis and power applied, it is fully operational as a layer 2 switch. 
 
Be sure to carefully follow the instructions for attaching the ZX4300P switch into an available 6U 
Compact PCI (cPCI) slot to prevent damage. For CPSB applications, the ZX4300P must be 
placed in a PICMG 2.16 compliant fabric slot.  If you intend to use a Rear Transition Board, a 
cPCI chassis is required that supports the rear panel I/O for a corresponding Rear Transition 
Board. Some steps in this procedure may vary depending on the specific system used.  
 
If the ZX4300P is installed in a non-CPSB chassis, i.e. a standard CompactPCI chassis, ensure 
the slot used does NOT contain an H.110 backplane. 

 
Refer to your specific system documentation for additional installation reference.  
1.  Power off your system. 
2.  Discharge any static electricity from your body by touching the metal chassis, or by using 

an anti-static wrist strap. If you do not have a ground strap, maintain physical contact with the 
case to maintain the same electrical potential with the system. 

1.  Select an available slot on your cPCI system and remove the slot cover from the front panel. 

For CPSB applications, choose a fabric slot. 

2.  Carefully insert the ZX4300P into the slot.  Be sure you push the card straight into the slot. 

The card and the slot must be properly aligned and the card fully seated. A card is seated 
properly when it touches the system case up to the extraction levers. 

3.  Push the extraction levers towards one another to finish seating the switch and secure the 

retention screws.