Manualsbrain.com
  1. Manuali
  2. Marche
  3. Panasonic
  4. Arbitrator 360
  5. Guida Al Funzionamento

Panasonic Arbitrator 360 Guida Al Funzionamento

Scarica
Pagina di 140
35
Additional Information  on Operation
Setting Item
Factory Default Value Description
1 Rec/Play
Recording and Playback Settings
PowerOff Time
∗
1
120
Time from the SIGNAL turn-off to recorder 
shut-down (minutes)
 Setting :  0, 10, 20, 30, 60, 90, 120, 180, 
AUTO
∗
2
Init Camera 
Select
1
Initial video input selection (upon power on)
 Setting : 1 ([CAMERA1] connector input)
   
2 ([CAMERA2] connector input)
  
LAST
∗
3
 
Init Audio2 In 
Select
INCAR
Initial source selection for Audio2 input 
(upon power on)
  Setting :  INCAR ([IN CAR MIC] connector input)
   
 WMIC
∗
4
 ([AUDIO IN 2] connector input)
  
LINK CAM
∗
5
  
LAST
∗
3
PowerOn Rec
OFF
Automatically start recording with power-on
  Setting :  ON, OFF
Loop Rec
OFF
Loop recording
  Setting :  OFF fixed
Intermittent Rec
OFF
Intermittent recording
  Setting :  ON, OFF
Resolution/
RecRate
Q-512k
Recording resolution and bit rate
 Setting :  Q-512k (320x240 pixel, 512 kbps)
   
 Q-1M (320x240 pixel, 1 Mbps)
   
 F-1M (720x480 pixel, 1 Mbps)
   
F-2M (720x480 pixel, 2 Mbps)
F-1M is 10 fps, and others are 30 fps
∗1  Depending on the vehicle, the battery may run out of power during operation.
∗2  When recorder operation is not controlled by a PC application: 
 
   Power is turned off immediately. Note, however, that power is not turned 
off while data is exported to a USB memory device, but is turned off after 
completion of data export. 
 
 When recorder operation is controlled by a PC application: 
 
   Power is turned off when control from a PC application is released, or when 
the PC card slot cover is opened.
∗3  Applies the setting in effect when power was last turned off. Unless power is 
turned off properly, the operating state may not be saved correctly.
∗4  WMIC is the abbreviation for Wireless Microphone.
∗5  In LINK CAM mode, being linked with the change of camera, Audio2 sound 
input changes. Changing to the [CAMERA1 (CAMERA2)] connector input, 
sound comes from the [AUDIO IN 2 (IN CAR MIC)] connector input.
Setup 
(continued)
Items administrators can set:
(Continued on the next page)