Pro-Ject Audio Systems PRO-JECT HEAD BOX MK II Manuale Utente
© Pro-Ject Audio · Pro-Ject Head Box · Revision 10.10.05/1.12.05
3
Technical specifications PRO-JECT HEAD BOX MK II
Power output
330mW/30ohms, 60mW/300ohms
Headphone connection
Min. 30ohms
THD (IMD)
0,005% (0,001%)
Gain 11dB
Signal to noise
Signal to noise
94dB ref. full output (112dB - A weighted ref. full output)
Frequency response
30Hz – 20kHz/-0,05dB (10Hz – 120kHz/-1dB)
Headphone jack
3-pole ¼“ (6,3mm ∅) phono jack
Outboard power supply
16V/200mA AC, suitable for your country's mains supply
Power consumption
16V/120mA AC
Dimensions (H x W x D)
38 x 105 x 120mm
Weight without power supply
600g
Potential incorrect use and fault conditions
No signal on one or both channels:
No connection between headphone and Head Box ore amplifier. This could be due
to a faulty plug, broken wire or solder joint or simply loose plug/socket connection.
Headphone does not work:
Headphone volume control is at minimum.
Amplifier Tape-Monitor circuit is not activated.
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
manufacturer from any liability over and above the lawful rights of the customer.
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: ATR-Audio Trade GmbH
Copyright © 2005
Audio Tuning GmbH. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.