ADIC Life Jacket FileServ Version 4.4.1601363 Manuale Utente
Page 4 of 16
FileServ Version 4.4.1—601363 Rev A
www.adic.com
Update
sysparm
File with Media Capacity
After an initial installation, if you add or change a Sony AIT-2, IBM 3590E1A, Quantum DLT 7000, or
Quantum DLT 8000 drive type, update the system parameters to reflect the new media capacity by
following the steps below:
Quantum DLT 8000 drive type, update the system parameters to reflect the new media capacity by
following the steps below:
Step 1.
Log in as
root
.
Step 2.
Edit the
fs_sysparms
file.
Step 3.
If you are adding an AIT-2 drive, update the
DEF_MED_SPC_AIT
parameter definition to be as
shown below if you are using 170m tape:
Quantum DLT 4000
Quantum DLT 7000. Configure this drive as a DLT 4000.
Quantum DLT 8000. Configure this drive as a DLT 4000.
Yes
Yes
Sony AIT-1 SDX-300
Sony AIT-2 SDX-500
Yes
Yes
Sony GY-10
Sony GY-2120
Sony GY-8240.See
During initial configuration on VolServ, set these drives up to support
both DTF1 and DTF2 media types.
both DTF1 and DTF2 media types.
Yes
Yes
Storage Technology 4480
Storage Technology Timberline 9490-E
Storage Technology 9840
Yes
Yes
NOTE: To tune the kernel for DST drives, follow the steps below:
Step 1: Login as
root
.
Step 2: Run
systune -i
.
Step 3: Enter
maxdmasz 513
.
Step 4: Enter
quit
.
Step 5: Reboot the system.
# vi /$FS_HOME/sysparms/fs_sysparms
DEF_MED_SPC_AIT=35000000000;
Drive Type
Supported
on IRIX
Supported
on Solaris