Whynter SNO IC-2L Manuale Utente

IC-2L 06/07

If the ice cream needs more time, do not turn “Off” the Main Power Switch (I).
Place the Lid/Churn Motor Assembly (E/G) in position, set the additional time
required and press the Red Start/Stop Switch to start the churn.

If the Churn Motor (G) was not turned “Off” after the set time elapsed, the Churn
Blade (H) will continue until the blade becomes stuck in the frozen ice cream. 30
seconds after being stuck, the buzzer will buzz and the Timer Display (J) will
flash. After 5 minutes, the Churn Motor (G) will shut “Off” automatically
preventing any damage to the motor. The buzzer and flashing display will
continue.

To, reset the machine, press the Red Start/Stop Switch and turn “Off” the Main
Power Switch (I). The churn blade and ice cream at this point will be frozen solid
and will require defrosting before it can be removed. Be careful not to damage
the removable bowl.

Always unplug the unit from the outlet when not in use.

If the Main Power Switch(I) is turned “Off”, always allow at least 3 minutes,
before turning it back ”On”.

Always keep the Ice Cream Maker in an upright position to avoid reduction of
cooling performance.

There will be a variation in the time it takes for a batch of ice cream to freeze,
depending on the amount and on the temperature of ingredients used. If you
want quicker results, use less ingredients and/or refrigerate the ingredients
before use.

For any faults which cannot be cleared and for further assistance and service the
contact information is shown on the next page.