Kentrox AI296 Manuale Utente

Pagina di 404
AI296 Version 9.8x User’s Guide
IP Over X.25 Subnet Configuration: Configuration Overview
5-2
Configuration Overview
AI296 supports encapsulation of the IP protocol over X.25 (IXE) networks. The local 
AI296 wraps IP packets (either control or data packets) inside of X.25 frames and 
sends them across the X.25 network. The remote AI296 receives the X.25 frames and 
unwraps the IP packets.
To allow IP traffic to run over an X.25 network, the network must be configured to 
support IP over X.25 encapsulation. To do this, complete the following tasks:
z
Configure and verify the X.25 SVC links. Refer to section 
 for information about configuring X.25 SVC links.
z
Create IP subnets and IP over X.25 remote pairs.
z
Create IP static routing table entries (optional).
z
Reset AI296.
Before Configuration
In order for the TCP/IP stack to know where to route incoming packets, an appropriate 
subnet must be configured. IP addresses and subnets must be assigned to the local 
and remote sides of the X.25 link (also called "doorway"). X.121 addresses are then 
assigned to the local and remote sides. After this, a static route can be setup through 
the IXE link to the remote doorway IP address. Refer to the example in 
 for an illustration of how to configure IP over X.25.
Figure 5-1   IXE Example
IP Tunnel
within X.25
11
8
Local AI296
Remote AI296
IP address: 198.127.1.196
IP address: 198.30.2.196
Local IXE doorway 
address: 20.0.0.1
Local IXE doorway
X.121 address:
3035550005
Subnet mask: 255.255.255.0
Subnet mask: 255.255.255.0
IXE subnet mask:
255.255.255.0
Remote IXE doorway 
address: 20.0.0.2
Remote IXE doorway
X.121 address:
6065550008
IXE subnet mask:
255.255.255.0
Link Numbers