Nortel Networks Nortel Passport 4400 Manuale Utente
20 Configuring an MPANL tunneled through public frame relay
241-6401-280 6.0S1
Configure the 4400
CLI> def msm profile dnaPrefix "302102100501"
The Prefix DNA normally derives from link information.
For example:
For example:
DNIC
3021
RID
02
MID
10
Lp
05
Port 01
CLI> set system administration nodename "MPA_1"
A nodename is not required, but is typically included. Although not shown
in this example, the nodename appears within the CLI prompt.
in this example, the nodename appears within the CLI prompt.
CLI> def fr tunnel 149
CLI> add fr tunnel 149 21 limi 2 dtepanl
CLI> def fr line user dlcmipvc 155 ansi
If using release 2.0, use the following two commands in place of the
previous three commands:
previous three commands:
CLI> def fr line user dlci lmitype 155 ansiT1617D-1994
CLI> define wan tunnelPVC dlci 153 21
where:
the 3rd party frame relay network supplies the DLCI number
the 3rd party frame relay network supplies the DLCI number
CLI> save config update
CLI> reset system current reset
Configure the 6400
> start prov
PROV> add sw lpt/MPANL_MUX
PROV> set sw lpt/MPANL_MUX featureList mpaNetworkLink
frameRelayMux frameRelayUni frameRelayMmtc
PROV> check prov
PROV> act prov
PROV> save prov