West Elm Teak Bath Sconce Double Istruzioni Di Montaggio
assembly instructions
page 2 of 2
To Assemble:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER.
2. Carefully unpack all fixture parts and hardware and lay out on a clear workspace.
3. Carefully inspect the chandelier's fixture wires. The NEUTRAL FIXTURE WIRE is white or marked “N”. The HOT
FIXTURE WIRE is black or marked “L”. The yellow-green or bare wire is the GROUND WIRE.
4. Attach the GROUND WIRE from the fixture to the GROUND JUNCTION BOX WIRE from the outlet (usually green or
bare wire). Fasten each together with a plastic wire connector (A) and wrap the connection with electrical tape. Be
sure that no wire strands are exposed. If your outlet box DOES NOT have a GROUND WIRE, be sure to insert the
green ground screw (B) into the mounting plate (L) facing DOWN, and wrap the fixture's bare ground wire around
the ground screw. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.
5. Connect the NEUTRAL FIXTURE WIRE to the NEUTRAL JUNCTION BOX WIRE (white). Fasten each together with a
plastic wire connector (A) and wrap the connection with electrical tape. Be sure no wire strands are exposed.
6. Connect the HOT FIXTURE WIRE to the HOT JUNCTION BOX WIRE (black). Fasten each together with a plastic wire
connector (A) and wrap the connection with electrical tape. Be sure no wire strands are exposed. DO NOT REVERSE
THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE COMPROMISED.
7. Gently tuck the wire connections neatly into the ceiling junction box.
8. Attach the mounting plate (L) to the ceiling outlet box using the enclosed mounting screws (C). Tighten screws
with a screwdriver.
9. Pull canopy (J) up over the mounting plate (L), align the hole in the mounting plate with the hole in the canopy.
10. Insert the canopy screw (D) tighten with a screwdriver.
11. Unscrew sockets ring (F) from the socket.
12. Place glass shade (H) on socket (I).
13. Place the metal ring (G) onto the socket (I).
14. Screw on the socket rings (F) and tighten with wrench.
Completing the Assembly:
1. Insert 2 x 60-watt Type B bulbs (not included) into the socket . DO NOT EXCEED SPECIFIED WATTAGE.
2. Restore power to junction box and test fixture.
3. Assembly is complete.
Care Instructions:
• Wipe clean using a soft, dry cloth or static duster.
• Always avoid the use of harsh chemicals and abrasives to clean fixture as they may damage the finish.
teak bath sconce double
5626213 - 03/08