Honeywell FLASHGUARD 2000B Manuale Utente

Page 11

 

 

 
 

•

 Located on the control panel (top center), this indicator is illuminated whenever input

power is present and the power supply interlock switch is engaged.

 
 

•

 Located on the high voltage circuit (top) board, this lamp indicates that the high

voltage circuits are active.

•

 Extreme caution should be used if the neon lamp is on.

 
 

•

 Located on the sync/monitor (middle) board, this LED will be green when the

flashhead is operating correctly.

•

 If the LED is off, the system is in alarm mode.

 
 

•

 Located on the sync/monitor (middle) board, this LED blinks red to indicate that a

sync signal has been generated.

•

 In a multiple flashhead system, only the sync/monitor board that is set as the master

will blink this LED.

 
 

•

 Located on the trigger/control (bottom) board, this LED blinks green to indicate that a

sync signal has been received from the sync/monitor board.

 

 

•

 Flat head screwdriver

•

 5/16” nutdriver to open flashhead

•

 Clean gloves to use when changing flashtubes

•

 Digital multimeter w/ Ohm reading and 500 VDC capacity

•

 NE2 neon light, Radio Shack catalog number 272-1102, Honeywell part # 77-2342

•

 Short piece of wire for jumper (Approx. #12 wire gauge)