Wayne ESP45 Manuale Utente

Pagina di 24
 © 2010 WAYNE Pumps
353502-001 3/10
24-Volt 
Backup Sump Pump
OPERATING 
INSTRUCTIONS 
AND PARTS 
MANUAL
PLEASE READ AND SAVE THESE INSTRUCTIONS. READ CAREFULLY 
BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN 
THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY 
OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH 
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY 
DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
DESCRIPTION
 The ESP45 is a battery operated back-
up sump pump. It does not replace a 
regular pump. It is designed to provide 
protection in the event household 
electrical power fails or main pump fails.
 UNPACKING
 I nspect this unit before it is used. 
Occasionally, products are damaged during 
shipment. If the pump or components are 
damaged, return the unit to the place of 
purchase for replacement. Failure to do so 
could result in serious injury or death.
 GENERAL SAFETY INFORMATION
 CALIFORNIA PROPOSITION 65
This product or its power cord contains 
chemicals known to the State of 
California to cause cancer and birth 
defects or other reproductive harm. 
Wash hands after handling.
GENERAL SAFETY
 
Do not use to pump 
fl ammable or explosive fl uids 
such as gasoline, fuel oil, 
kerosene, etc. Do not use in a fl ammable 
and/or explosive atmosphere. Personal 
injury and/or property damage could result.
 For parts, product & service information
visit www.waynepumps.com
 REMINDER: Keep your dated proof of purchase for warranty purposes! 
Attach it to this manual or file it for safekeeping.
SPECIFICATIONS
Power supply requirements .......... 120V, 60 Hz
Motor .............................................. Permanent Magnet DC Motor
Normal water removal .................. 2880 GPH @5 ft. @ 26V DC
Liquid temperature range ............ 40º F to 120º F
Circuit requirements ...................... 5 amps AC (min)
Pump Dimensions .......................... 11 inch high x 8-3/4 inch base
Pump Run Time .............................. 15 Seconds
CONSTRUCTION
Motor housing .........................Cast Iron
Impeller .....................................Thermoplastic
Shaft seal ..................................Stainless Steel
Discharge ..................................1-1/2 inch NPT
Float Switch ..............................Reed Style
 
 
Disconnect power before 
servicing. If the power 
dis con nect is out of sight, lock 
in the open po si tion and tag it to prevent 
unexpected application of power. Failure to 
do so could result in fatal electrical shock!
 
If the basement has water or moisture on 
the floor, do not walk on wet area until 
all power is turned off. If the shutoff box 
is in the basement , call an electrician. 
Remove pump and either repair or 
replace. Failure to follow this warning 
could result in fatal electrical shock.
 
 
All wiring must be performed by a 
qualifi ed electrician.
 
Do not expose battery to 
sparks or fl ames as an 
explosion or fi re could result.
 
Battery acid is corrosive. 
Avoid spilling on skin or 
clothing. Eye protection must 
be worn when handling the battery.
 
A check valve must be used on the 
primary sump pump discharge.
 SAFETY GUIDELINES
 This manual contains information 
that is very important to know 
and understand. This information 
is provided for SAFETY and to 
PREVENT EQUIPMENT PROBLEMS. 
To help recognize this information, 
observe the following symbols.
Danger indicates an imminently 
hazardous situation which, if not 
avoided, WILL result in death or serious 
injury.
Warning indicates a potentially 
hazardous situation which, if not 
avoided, COULD result in death or 
serious injury.
 
 
Caution indicates a potentially 
hazardous situation which, if not 
avoided, MAY result in minor or 
moderate injury.
 
Notice indicates important 
information, that if not followed, 
may cause damage to equipment.
MODEL 
ESP45