Westinghouse L2210NW Manuale Utente

3 

The power supply outlet should be located near the LCD Monitor and should be easily accessible. 

Always use the appropriate AC cord that is certified for your specific country. Some examples are listed below:

 

USA.................. UL 

Switzerland ..........  SEV 

Canada............. CSA 

Britain 

..................  BASE/BS 

Germany........... VDE 

Japan .................. 

Electric Appliance Control Act 

 

 

The specific power cord for this LCD Monitor is enclosed and has been selected according to the country of 
destination and must be used to prevent electric shock. Use the following guidelines if it is necessary to replace 
the original cord set, or if the cord set is not enclosed. The female receptacle of the cord set must meet 
IEC-60320 requirements and should look like Figure A1 below: 

 

 

 

In the United States and Canada the male plug is a NEMA5-15 style (Figure A2), UL Listed, and CSA Labeled. 
For LCD Monitors that are placed on a desk or table, type SVT or SJT cord sets may be used. For LCD Monitors 
placed directly on the floor, only SJT type cord sets may be used. The cord set must be selected according to 
the current rating for the LCD Monitor. Please consult the table below for the selection criteria for power cords 
used in the United States and Canada. 

 

 

  Maximum Current Rating of Unit

SJT 

18 AWG 
16 AWG 
14 AWG 

10 Amps 
12 Amps 
12 Amps 

SVT 

18 AWG 
17 AWG 

10 Amps 
12 Amps 

 
 

This equipment has been tested and complies with the limits for a Class B digital device, pursuant to part 15 of 
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, and can radiate radio frequency energy, and may cause 
harmful interference to radio communications if not installed and used in accordance with the instructions. 
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the following measures: 
 

•  Reorient or relocate the receiving antenna. 

•  Increase the separation between the LCD Monitor and receiver. 

•  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

•  Consult the Westinghouse Service Center or an experienced radio/Monitor technician for assistance. 

 

To assure continued FCC compliance, the user must use a grounded power supply cord and the provided 
shielded video interface cable with bonded ferrite cores. If a BNC cable used, use only a shielded BNC (5) cable. 
Also, any unauthorized changes or modifications not expressly approved by Westinghouse Digital Electronics 
will void the user's authority to operate this device.