Heart & Home Collectables GFK-210 Manuale Utente

1

Hearth & Home Technologies  •  GFK-210 Blower System Instructions  2206-938 Rev. H  •  7/11

The GFK-210 Blower System has been designed to circu-
late room air through the fi replace to enhance heat output. 
The GFK-210 blower system operates on 120 VAC, 60 Hz 
power. This is available through a receptacle in the factory 
installed power cord assembly. The power cord is located 
in the controls compartment of the fi replace. 

A variable speed control is provided with the blower system 
to provide quiet forced air fl ow at the desired speeds. A 
temperature sensor switch, which automatically turns the 
blower ON/OFF, is also provided with this kit.

Compare CONTENTS OF CARTON in Figure 1 with the 
actual parts received. If any parts are missing or damaged, 
contact your dealer before starting installation. Do not install 
a damaged blower kit.

The GFK-210 Blower Kit is tested and safe when installed in 
accordance with this installation manual. It is your responsi-
bility to read all instructions before starting installation and to 
follow these instructions carefully during installation to assure 
maximum benefi t from, and safe operation of, the blower.

NOTE:  Install the blower using the access panel located on 
the back side of the appliance.

1.  Remove factory-installed blower brackets by removing 

four screws.  Brackets are only used for the FireBrick 
inserts.  See Figure 2.

2.  Remove appliance from wall.

3.  Remove access panel by removing four screws.  See 

Figure 3.  

4.  Screw blowers to access panel on rear of insert with 

four screws.  See Figure 4.

5.  Plug the blower cord into the blower receptacle.  Con-

nect the white, black, and green spade connectors 
from blower cord harness to each blower.  See Figure 
1 and Figure 6.

6.  Bundle and zip tie any wires to keep them from contact-

ing the fan blades.  See Figure 6, Detail A.

7.  Reinstall access panel.

This blower is carefully engineered and must be installed 
only as specifi ed. If you modify it or any of its components, 
you may cause a fi re hazard and will void the WARRANTY. 
In addition, such action may void the coverage provided 
by the owner's home insurance.