Harbor Freight Tools 4 in. Handheld Dry_Cut Tile Saw Manuale Del Prodotto
Page 12
For technical questions, please call 1-888-866-5797.
Item 62296
SAFETY
Op
ERA
TION
ERA
TION
M
AINTENANCE
SETU
p
p
Cutting Depth Adjustment
1. Loosen the Wing Bolt (39) attaching the
Protection Cover (5) grooved bracket
welded to the Base Plate (37).
2. Move motor housing up and down until
the desired depth (below base plate) is achieved.
See Figure C.
WARNING! To reduce the risk of serious injury,
adjust the depth of cut to just barely clear
the work piece and remove dust.
3.
WARNING! Tighten Wing Bolt (39) before use.
Figure C
Work piece and Work Area Set Up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose work pieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
This is especially critical for plunge cuts.
General Operating Instructions
1. Make sure that the Trigger is in the
off-position, then plug in the tool.
2.
Make sure that all guards are in place and in
proper working order and that all adjustment
knobs are tight before operation.
3. Set front end of the Base Plate down against
the tile surface without the blade touching
the saw blade to the work piece.
4. Press the Trigger to turn on Tile Saw.
5. Allow Tile Saw to reach full speed
before beginning to cut.
6. Slowly slide Tile Saw forward, beginning to cut.
See Figure D.
7.
WARNING! If cutting tile that is 3/4” or thicker,
make two separate cuts to reduce motor wear.
8. For continuous operation, press the Trigger
and then press the trigger lock switch on
the side of the handle. Press trigger lock
switch again to release the trigger lock.
9. To prevent accidents, turn off the tool and
unplug it after use. Clean, then store the
tool indoors out of children’s reach.
Figure D