GSI Outdoors 100 SERIES DRYER PNEG-552 Manuale Utente

PNEG-552 100 Series Dryer 

A multimeter is required for some of the following checkout procedures. Before performing any tests, 
determine if the dryer power supply is 1 phase, 230 volt, or 3 phase, 230 or 460 volt.

•  The burner circuit is 120 volts AC on all standard U. S. production models.

•  The control circuit to the motor starters is 120 volts AC.

•  The safety circuit is 12 volts DC.

•  When checking these circuits, measure voltage between the circuit test location and to ground.

•  DC circuits should be measured between the test location and its respective DC ground. Refer to

 and the parts list for identification of parts and the electrical terminals. 

Control power light OFF.

1. Check that main power and circuit breakers are turned ON. 

Check for tripped breaker.

2. Check for blown 5 amp fuses.

3. Monitor relay is defective.

4. Defective transformer or wiring.

5. Check for a defective power switch.

6. Check wiring between fuses and input/output board. Refer to 

 for test locations.

Control power is ON. Drying mode light OFF.

1. Power interruption: Incoming power to the dryer has been 

interrupted. The display screen will show the date and time if this 
has occurred, once power has returned.

This indicates control power is present at 
input/output board, but no power is being 
transferred through the I/O board.

2. Display not finished initial setup: The monitor will display a 

copyright message and model number, total running time in 
hours and minutes and then the current date and time. To 
activate the controller press the reset button.

3. Input/output board: The input/output board has developed a 

problem that requires its replacement.

 No display on LCD screen.

1. Check for a defective power switch.

2. Check wiring between fuses and input/output board.

3. Check for 120 volts AC between points J6-02 and AC-1.

4. The display may have a malfunction requiring its replacement.

Control power light is ON, drying mode light is 
ON-load auger, fan, heater, unload auger does not 
operate.

1. Press the dryer power start button.

2. Refer to the problem listed for load auger, fan heater and unload 

auger in the following sections.

Display shows “MOTOR OVERLOAD” message.

The thermal overload on the fan motor, load motor, unload motor or 
an auxiliary motor has opened indicating an overloaded motor. 
(The overloads must be manually reset.)

Display shows “VAPOR HIGH TEMPERATURE” 
message.

The LP gas vapor temperature sensor located in the gas train 
downstream from the vaporizer has opened, indicating that the 
vaporizer is running too hot and must be readjusted. (This control 
is a 200°F limit which automatically resets when it cools.)

Display shows “LOSS OF FLAME” message.

The flame sensor has failed to detect a burner flame, indicating 
that the burner has failed to light. There is a problem with the flame 
sensing circuitry or the dryer is not getting burner fuel.