Guardian Fall Protection Guardian Fall ProtectionGuardian Fall Protection GPS Receiver 6200 Manuale Utente

Guardian 6200

Copyright © 2006 Guardian Mobile Monitoring Systems, Inc.   All rights reserved.
www.guardianmms.com

•  The Auxiliary input can be used to detect and report a 

change of voltage – both low to high and high to low. 
Connect a switch or relay from your alarm system 
or any other switched device to be monitored. When 
closed, the switch must connect 12 Volts power to pin 
10 (white wire) of the wiring harness connector. When 
open, the switch must connect pin 10 of the wiring 
harness to ground (0 Volts) or to nothing at all.

•  Following the wiring diagram, connect a panic button 

to pin 6 (green wire) of the wiring harness connector, 
connect the other terminal of the button to 12V power. 
The Panic button must be a momentary contact 
switch that connects 12 Volts power to pin 6 when it is 
pressed.

A auxiliary input and/or panic button may be connected to the beacon.

•  For the first test, the vehicle should be outdoors in an open area where GPS signals can be readily received

•  Watch the indicator LED on the beacon for the first few minutes after all power and antennas have been connected. 

It indicates the following status:

•  Ensure that the indicator LED is showing flashing orange. 

•  Perform an end-to-end system test by locating the beacon via the user portal

Green/Steady

GSM Connection established

Green/Flashing

GPRS Data being transferred

Orange/Steady

Searching for satellites – no fix

Orange/Flashing

GPS fix acquired

NOTE 

It may take up to an hour for the 
wireless network and the GPS 
receiver to synchronize the first 
time the beacon is powered up

.

•  Connect the two antenna cables to the beacon 

using the corresponding coaxial connectors

•  Attach the wiring harness to the beacon and ensure 

that the retaining clip snaps in place

•  Affix the beacon securely to the vehicle using the 

mounting plate and screws provided. Drill mounting 
holes as required

•  If a suitable panel for affixing the supplied mounting 

plate is not available, fastening the beacon to a 
bracket or wire bundle with plastic cable ties is also 
adequate

•  Coil and secure any loose or extra length wire