Brother XL-3510 Guida All'Installazione Rapida
14
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
MAKING AN EMBROIDERED APPLIQUÉ FROM A ONE-POINT PATTERN
Inserting a thread cartridge
1
1
1
1
Hold the thread cartridge as shown in the
diagram, and then align the guide on the thread
cartridge with the groove in the thread cartridge
slot.
cartridge with the groove in the thread cartridge
slot.
1 Guide
2 Groove
2 Groove
2
2
2
2
Slide the thread
cartridge into the
thread cartridge slot.
thread cartridge slot.
3
3
3
3
Swing down the back end of the thread cartridge
until it locks in place.
1
2
NOTE
•
Be sure to take the needle guard cap off the
needle before inserting the thread cartridge.
needle before inserting the thread cartridge.
•
Check that about 3/4” to 1” (2 to 3 cm) of
thread hangs out of the bottom of the
cartridge. If it does not, see the section
Pulling the thread end out of the cartridge on
page 45.
thread hangs out of the bottom of the
cartridge. If it does not, see the section
Pulling the thread end out of the cartridge on
page 45.
CAUTION
•
Insert the thread cartridge after selecting the pattern and when the screen showing
the thread ID number appears.
the thread ID number appears.
•
Before inserting the thread cartridge, make sure there is enough thread in it. Plan
ahead when sewing chenille texture embroidery, since it uses more thread than
standard embroidery.
ahead when sewing chenille texture embroidery, since it uses more thread than
standard embroidery.