Manualsbrain.com
  1. Manuali
  2. Marche
  3. Brother
  4. XL-3510
  5. Guida All'Installazione Rapida

Brother XL-3510 Guida All'Installazione Rapida

Scarica
Pagina di 66
42
 
●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ●  ● 
STOPPING AND CONTINUING EMBROIDERING
4
Press the 
 key to go back to the point 
where sewing stopped.
Align the hole in the thread cartridge slot (shown by the 
arrow at the right) with the point where sewing stopped.
Go back a little before the point where sewing stopped 
so the stitches will overlap a little.
5
Press the 
 key.
The screen displayed in step 1 appears again.
6
Insert the thread cartridge, and then press the 
 key to continue sewing.
 Key information
•
If you go back too far, press the 
 key.
 NOTE
•
If the screen shown at the right appears, the 
thread cartridge was not removed. Remove 
the thread cartridge.
•
If it is difficult to find the point where sewing 
stopped, insert the thread cartridge, and then 
align the needle with the desired position.
 Key information
•
Pressing the 
 key goes back to step 1.
•
To go back to step 3, press the 
 key.
 NOTE
•
If embroidering is stopped and restarted, some extra needle holes may be punched in the 
pre-cut design fabric, but it can still be used.
•
If you wish to remove the design frame, press the 
 key, and then pull it out. (See the