Biostar P4VTG Manuale Proprietario
P
P
4
4
V
V
T
T
G
G
9
2.2 M
EMORY
M
ODULES
Supports up to 2 DDR devices.
Supports 266/333/400 MHz DDR devices.
Maximum memory size is up to 2 GB.
DIMM Socket
Location
DDR Module
Total Memory Size
(MB)
DIMM1 128MB/256MB/512MB/1GB
*1
DIMM2 128MB/256MB/512MB/1GB
*1
Max is 2 GB.
DDR M odule installation
1. Unlock a DIMM slot by pressing the retaining clips outward. Align a
DIMM on the slot such that the notch on the DIMM matches the
break on the Slot.
break on the Slot.
2. Insert the DIMM vertically and firmly into the slot until the retaining
chip snap back in place and the DIMM is properly seated.
2.3 J
UMPERS
,
H
EADERS
,
C
ONNECTORS
,
&
S
LOTS
Floppy Disk Connector: FDD1
The motherboard provides a standard floppy disk connector that
supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. This
connector supports the provided floppy drive ribbon cables.
supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. This
connector supports the provided floppy drive ribbon cables.
Hard Disk Connectors: IDE1~2
The motherboard has a 32-bit Enhanced PCI IDE Controller that
provides PIO Mode 0~5, Bus Master, and Ultra DMA 33/ 66/ 100
functionality. It has two HDD connectors IDE1 (primary) and IDE2
(secondary).
provides PIO Mode 0~5, Bus Master, and Ultra DMA 33/ 66/ 100
functionality. It has two HDD connectors IDE1 (primary) and IDE2
(secondary).
The IDE connectors can connect a master and a slave drive, so you
can connect up to four hard disk drives. The first hard drive should
always be connected to IDE1.
can connect up to four hard disk drives. The first hard drive should
always be connected to IDE1.
Peripheral Component Interconnect Slots: PCI 1~5
This motherboard is equipped with 5 standard PCI slots. PCI stands for
Peripheral Component Interconnect, and it is a bus standard for
Peripheral Component Interconnect, and it is a bus standard for