Biostar TForce 945P Manuale Proprietario
Biostar T-Series
TForce 945P
User’s Manual
40
4.4 T
ROUBLESHOOTING
Problem Solution
1. No power to the system at
all Power light don’t
illuminate, fan inside power
supply does not turn on.
illuminate, fan inside power
supply does not turn on.
2. Indicator light on keyboard
does not turn on.
1. Make sure power cable is
securely plugged in.
2. Replace
cable.
3. Contact technical support.
System inoperative.
Keyboard lights are on,
power indicator lights are lit,
and hard drive is spinning.
Keyboard lights are on,
power indicator lights are lit,
and hard drive is spinning.
Using even pressure on both
ends of the DIMM, press
down firmly until the module
snaps into place.
ends of the DIMM, press
down firmly until the module
snaps into place.
System does not boot from
hard disk drive, can be
booted from optical drive.
hard disk drive, can be
booted from optical drive.
1. Check cable running from
disk to disk controller board.
Make sure both ends are
securely plugged in; check
the drive type in the standard
CMOS setup.
Make sure both ends are
securely plugged in; check
the drive type in the standard
CMOS setup.
2. Backing up the hard drive is
extremely important. All hard
disks are capable of breaking
down at any time.
disks are capable of breaking
down at any time.
System only boots from
optical drive. Hard disk can
be read and applications
can be used but booting
from hard disk is
impossible.
optical drive. Hard disk can
be read and applications
can be used but booting
from hard disk is
impossible.
1. Back up data and application
files.
2. Reformat the hard drive.
Re-install applications and
data using backup disks.
data using backup disks.
Screen message says
“Invalid Configuration” or
“CMOS Failure.”
“Invalid Configuration” or
“CMOS Failure.”
Review system’s equipment.
Make sure correct information
is in setup.
Make sure correct information
is in setup.
Cannot boot system after
installing second hard
drive.
installing second hard
drive.
1. Set master/slave jumpers
correctly.
2. Run SETUP program and
select correct drive types. Call
the drive manufacturers for
compatibility with other drives.
the drive manufacturers for
compatibility with other drives.