Energy Speaker Systems LTV46DA Manuale Utente

13

Connections and Start of Operation

If the television set does not receive any signal, adjust the output of the computer.
For information on how to setup the computer, refer to the corresponding manual 
of the computer.

If the external equipment has mono audio output, connect it only to left socket of
the audio input/output.

You can use the television set as a monitor for the computer. This is possible parallel to television operation. 
Use a 15-pin D-Sub cable to connect the television set to the computer.

1 Plug the cable into the output socket of the 

graphic board.

2 Plug the other end of the cable into the socket 

[RGB].

3 Connect the audio cable according to the 

colours to the socket [PC Sound] on the 
television set and the output sockets of the 
graphic board.

Adjust the settings of the television picture 
corresponding to the settings for television
operation. See “Settings” on Page 16.

You can use the television set to connect DVD recorder/player and set-top-box. Connect the audio and video cables
from the external equipment's output jacks to the TV input jacks, as shown in the figure. When connecting the TV to
external equipment, match the jack colors.

➣  Connecting to External Devices 

1 Plug the video cable according into the colours to 

the output sockets of the external devices.

2 Plug the other end of the video cable according to

the colours into the Y, Pb, Pr sockets
[AV 3 or AV 4] on the television set.

3 Plug the audio cable according to the colours to

the audio output sockets of the external devices.

4 Plug the other of the audio cable according to the 

colours into the audio input socket on the 
television set.

1027_A50-095300_Eng  10/27/06  9:44 PM  Page 13