Manualsbrain.com
  1. Manuali
  2. Marche
  3. Brother
  4. HL-6050DN
  5. Manuale Proprietario

Brother HL-6050DN Manuale Proprietario

Scarica
Pagina di 179
6 - 1   TROUBLESHOOTING
6
LCD messages
If any problems occur, the printer automatically stops printing, diagnoses the problem, and displays the 
resulting message on the LCD to alert you. Take the appropriate action, referring to the following tables. 
If you cannot clear the problem, call the dealer you bought the printer from or Brother Customer Service.
Troubleshooting
If you do not follow the instructions for using the printer, you may be responsible for all repairs.
The LCD names for the paper trays are as follows.
Upper paper tray
TRAY 1
Multi-purpose tray
MP TRAY
Optional Lower tray 
TRAY 2
Error messages
Error message
Action
BACK TRAY CLOSED
Open the back output tray. Push down the two blue levers, and then press Go.
BACK TRAY OPEN
Close the back output tray located at the back of the printer.
BUFFER ERROR
Check the Interface settings.
CARD ERROR
Make sure of the following:
The CompactFlash
TM
 card is installed properly.
The installed CompactFlash
TM
 card is formatted properly 
Turn off the printer. Wait a few seconds, then turn it on again. If this error message 
appears again, replace the CompactFlash
TM
 card with a new one.
CARTRIDGE ERROR
Take out the toner cartridge and put it back into the printer again. See Replacing the 
toner cartridge on page 5-3.
CHECK NET BOARD
The istalled network board is not compatible. Please install the recommended network 
board.
CHECK NET VER.
The firmware version of the installed network board is not up to date. Please update the 
firmware by accessing the Brother Solutions Center at http://solutions.brother.com
CLEAN DRUM UNIT
Open the front cover. Take out the drum unit assembly. Gently slide the blue tab of the 
drum unit across several times.
DIMM ERROR
Re-install the DIMM correctly.
Turn off the printer. Wait a few seconds, and then turn it on again. If this error message 
appears again, replace the DIMM with a new one.
DOWNLOAD FULL
DX LEVER ERROR
Move the lever at the back of the printer to the correct paper size position; A4, Letter or 
Legal
ERROR FUSER
Turn the power switch off, wait a few seconds and then turn it on again.
Leave the printer for 15 minutes with the power on.
FONT FULL