Brother 1034D Manuale Utente
23
TABLE OF
CONTENTS
Chapter
1
Chapter
2
Chapter
3
Chapter
4
Chapter
5
Chapter
6
Chapter
7
Chapter
8
Chapter
9
Chapter
10
Chapter
11
Chapter
12
Chapter
13
Chapter
14
Chapter
15
Chapter
16
Chapter
17
Chapter
18
Threading the left needle
•
Run the thread in the sequence illustrated, follow-
ing the yellow color and the numbers next to each
threading point.
ing the yellow color and the numbers next to each
threading point.
1
Pull the thread off the spool and directly up
through the thread guide on the thread tree
from back to front.
through the thread guide on the thread tree
from back to front.
2
Pull the thread about an extra 15cm (6
inches) through the front of the thread tree.
inches) through the front of the thread tree.
3
Pass the thread through the proper thread
guide.
guide.
4
Slide and hold the thread tension release
button to the right, then pass the thread
through the tension disc which is in the
channel next to the yellow tension adjust-
ment dial. Release the button.
button to the right, then pass the thread
through the tension disc which is in the
channel next to the yellow tension adjust-
ment dial. Release the button.
5
Guide the thread down the channel and
across through the threading points next to
the yellow color marks following the nu-
merical order in the accompanying illustra-
tion.
across through the threading points next to
the yellow color marks following the nu-
merical order in the accompanying illustra-
tion.
6
Bring the thread down through the guide 7
above the needle and through the left
needle from front to back.
above the needle and through the left
needle from front to back.
Enhebrado de la aguja
izquierda
•
Enhebre la aguja tal como ilustrado en la secuen-
cia, respetando el color amarillo y los números
inscritos al lado de cada punto de enhebrado.
cia, respetando el color amarillo y los números
inscritos al lado de cada punto de enhebrado.
1
Saque el hilo del carrete y póngalo direc-
tamente por la guía de enhebrado del
árbol de enhebrado desde detrás a delan-
te.
tamente por la guía de enhebrado del
árbol de enhebrado desde detrás a delan-
te.
2
Tire del hilo otros 15 cm aproximadamente
por la parte delantera del árbol de enhe-
brado.
por la parte delantera del árbol de enhe-
brado.
3
Pase el hilo por la guía de hilo correspon-
diente.
diente.
4
Deslice y retenga el botón de liberación de
la tensión del hilo hacia la derecha, y pase
el hilo por el disco de tensión que es el
canal situado al lado del disco de ajuste de
la tensión amarillo. Suelte el botón.
la tensión del hilo hacia la derecha, y pase
el hilo por el disco de tensión que es el
canal situado al lado del disco de ajuste de
la tensión amarillo. Suelte el botón.
5
Guíe el hilo por el canal y pase el hilo a
través de los puntos de enhebrado al lado
de las marcas de color amarillo siguiendo
el orden numérico de la ilustración.
través de los puntos de enhebrado al lado
de las marcas de color amarillo siguiendo
el orden numérico de la ilustración.
6
Baje el hilo por la guía 7 por encima de la
aguja y por la aguja izquierda desde de-
lante a atrás.
aguja y por la aguja izquierda desde de-
lante a atrás.