BENDIX BW2600 Manuale Utente

Pagina di 4
The following Application Guideline is a point system that is calculated based on Vehicle Configuration 
and Vocation Options. Fill in points accordingly — on each line — and refer to Page 2 for dryer selections. 
If a particular entry is not valid for an application, then enter ZERO (0) on that line. Refer to Page 3 for 
example applications.
V
ehicle
 c
onfiguration
 
P
oints
  1.  Vehicle is equipped with bulk offloading or central tire inflation. 
See Note 1
  2.  For every axle (tractor and trailer – including lifts): Add 1.0 point
  3.  For each non-steerable lift axle (additional points): Add 1.0 point
  4.  For each steerable lift axle (additional points): Add 0.5 point
  5.  Tractor and/or trailer is equipped with air suspension. Add 0.5 point
V
ocation
 o
Ptions
 (
choose
 
the
 
one
 
that
 
best
 
fits
)
  6.  Vehicle is used as a city transit bus. 
See Note 2
  7.  Vehicle is used for pickup & delivery.
  8.  Vehicle is used for residential refuse. Add 4.5 points
  9.  Vehicle is used for rural or commercial refuse. Add 1.0 point
10.  Vehicle is used as a dump truck or concrete mixer. Add 1.0 point
11.  Vehicle is used for logging or construction. Add 1.0 point
12.  Vehicle is used for line haul.
a) Non-fuel hauler: Add 0.5 point
b) Fuel hauler: Add 1.0 point
a) Single trailer No Points:
b) Pulling three (3) to five (5) axles
on any trailer/dolly combination:
Subtract 1.5 points:
c) Pulling six (6) or more axles on
any tailer/dolly combination:
Subtract 2.5 points:
Add lines 1-12
and use this value 
on Page 2
1
 
Vehicles equipped with either bulk offloading or central tire inflation are required to use two air dryers with a Bendix
®
 EverFlow
®
 controller 
assembly.  No points need to be calculated. Refer to Page 2 for proper dryer selection.
Requires an Extended Purge version of the dryer (AD-9
®
 EP,  AD-9si
 EP, AD-IP
®
 EP, AD-IS
®
 EP). No points need to be  
calculated. Refer to Page 2 for proper dryer selection.
CONTROLLED ELECTRONIC MEDIA DOCUMENT: Verification of revision level or adequacy is required prior to use.
{
AIR DRYER APPLICATION GUIDELINE
1