BENDIX BW2083 Manuale Utente

2. Drill the three marked mounting holes into the frame

rail using a 5/8" diameter drill.

3. By hand, install the studs into the three corresponding

holes on the air dryer.  To tighten attach vise grips to the
studs within 1" of the air dryer and turn 1/4 to 1/2 turns.
Thread damage on the stud in the area near the air dryer
is acceptable.  Care should be taken to prevent damage
to the last 1-1/2 inches of the stud at the end opposite
the air dryer end cover.

4. Place a rubber grommet with the flat side toward the air

dryer over each of the installed studs.

5. Align and insert the air dryer mounting studs with

grommets into the 3 mounting holes on the vehicle frame
rail.  The raised portion or shoulder of the grommets
must fit into the mounting holes drilled into the frame
rail.

6. Install the remaining grommets on each of the mounting

studs with the raised portion or shoulder toward the frame
rail.  Ensure the shoulder fits into the frame rail mounting
hole.

7.   Using the flat washer and locknut secure the air dryer.

Tighten the locknuts using a 9/16" wrench turn until the
locknut, washer and outside grommet just make contact
(no actual compression of the rubber grommet) then turn
two(2) more turns.

Follow Figure 4 for air hose arrangement.

1. The Trailer System-Guard

™

 air dryer supply and control

line fittings are 1/4"-18 NPT. Cut the supply and control
lines and install 1/4 inch fittings.

Trailer System Guard

™

 Air Dryer

Grommet

Stud

Washer

Locknut

Grommet

Frame Rail

Vise Grip

Clamping Area

Template for mounting holes

T

emplate 10.25 inches

Template for mounting holes

2.0 inches