Westinghouse One-Light Indoor Mini Pendant 6701700 Manuale Istruttivo

4

NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires.  These
fixtures meet all UL specifications.

1.  Turn off power at circuit box to avoid possible electric shock.

2.  Thread mounting screws (A) into cross bar (B) approximately 1/4 inch (see fig. 1).  

3.  Secure cross bar (B) to outlet box (C) with outlet box screws (D).

4.  Select number of stems (E) to install based on desired fixture length, then connect stems (E).

5.  Thread fixture wires up through stem(s) (E), coupling (F), and canopy (G).

6.  Thread stem(s) (E) into socket assembly (H) and into coupling (F).

7.  Identify color coding of fixture wires (see fig. 2).

8.  To connect wires, take black fixture wire (group A from fig. 2) and place evenly against

black outlet box wire. Do not twist wires.

9.  Fit wire connector (I from fig. 1) over wires and twist until there is a firm connection. If wire

connector (I) easily comes off, reattach and check again for a firm connection.

10.  Repeat steps 8 and 9 with the white (group B from fig. 2) fixture wires and outlet box wires.

11.  Partially thread green grounding screw (J) into side hole (K) on cross bar (B) (see fig. 1).

12.  Wrap ground wire from fixture around green grounding screw (J) leaving enough excess 

wire to then connect ground wire and outlet box wire with wire connector (I), if applicable.

13.  Tighten green grounding screw (J). Do not over tighten.

14.  Tuck wires inside outlet box (C).

Warning: This fixture is for indoor use only.

1.  Raise canopy (G) to ceiling, allowing mounting screws (A) to protrude through openings in 

canopy (G), and secure into place with cap nuts (L) (see fig. 1).

2.  Raise glass shade (M) up to socket assembly (H) and secure with washer (N), if applicable,

and retaining ring (O). 

3.  Install lamp(s). Do not exceed recommended wattage.

4.  Turn power back on at circuit box.

12 pg_W-183_EFS  1/10/05  9:58 PM  Page 4