Wayne-Dalton IDRIVE 3982 Manuale Utente
3
IMPORTANT SAFETY INSTRUCTIONS FOR
INSTALLATION AND USE
IMPORTANT SAFETY INSTRUCTIONS FOR
INSTALLATION AND USE
READ AND FOLLOW ALL
INSTALLATION INSTRUCTIONS.
INSTALLATION INSTRUCTIONS.
Do not connect the opener to a
power source until instructed to do
so.
power source until instructed to do
so.
Where possible, install the opener
seven feet or more above the fl oor.
Mount emergency release six feet
above the fl oor.
seven feet or more above the fl oor.
Mount emergency release six feet
above the fl oor.
Locate the wall station: (a) within
sight of door, (b) at a minimum
height of fi ve feet, so small children
cannot reach it, and (c) away from
all moving parts of the door.
sight of door, (b) at a minimum
height of fi ve feet, so small children
cannot reach it, and (c) away from
all moving parts of the door.
After installing the opener, the door
must reverse when it contacts a
1-1/2” high object (or 2 x 4 board
laid fl at) on the fl oor.
must reverse when it contacts a
1-1/2” high object (or 2 x 4 board
laid fl at) on the fl oor.
WARNING: INCORRECT
INSTALLATION CAN
LEAD TO SEVERE OR
FATAL INJURY. FOLLOW
INSTRUCTIONS.
WARNING: IT IS VITAL
FOR THE SAFETY OF
PERSONS TO FOLLOW
ALL INSTRUCTIONS. SAVE
THESE INSTRUCTIONS.
Install the entrapment warning
label next to the wall station in
a prominent location. Install the
emergency release marking on or
next to the emergency disconnect.
label next to the wall station in
a prominent location. Install the
emergency release marking on or
next to the emergency disconnect.
Remove all ropes and remove
or make inoperative all locks
connected to the garage door before
installing the opener.
or make inoperative all locks
connected to the garage door before
installing the opener.
Do not wear rings, watches or loose
clothing when installing or servicing
a garage door system.
clothing when installing or servicing
a garage door system.
Install only on a properly balanced
garage door. An improperly
balanced door could cause severe
injury. Have a qualifi ed service
person make repairs to cables,
spring assemblies, and other
hardware before installing the
opener.
garage door. An improperly
balanced door could cause severe
injury. Have a qualifi ed service
person make repairs to cables,
spring assemblies, and other
hardware before installing the
opener.
NOTE:
This equipment has been tested and found to comply with limits for a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate ra-
dio frequency energy and, if not installed and used in accordance with these instruction, may cause
harmful interference to radio communication; however, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning equipment off and on, user is encouraged to try to
correct interference by one or more of the following measures: Reorient or relocate receiving antenna.
Increase separation between equipment and receiver. Connect equipment into an outlet on a circuit
different from that which receiver is connected. Consult your dealer or/and experienced radio/television
technician for help. WARNING: Changes or modifi cations to this unit not expressly approved by party
responsible for compliance could void user’s authority to operate this equipment.
harmful interference in a residential installation. This equipment generates, uses and can radiate ra-
dio frequency energy and, if not installed and used in accordance with these instruction, may cause
harmful interference to radio communication; however, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning equipment off and on, user is encouraged to try to
correct interference by one or more of the following measures: Reorient or relocate receiving antenna.
Increase separation between equipment and receiver. Connect equipment into an outlet on a circuit
different from that which receiver is connected. Consult your dealer or/and experienced radio/television
technician for help. WARNING: Changes or modifi cations to this unit not expressly approved by party
responsible for compliance could void user’s authority to operate this equipment.
Installation and wiring must comply
with local building and electrical
codes. Connect power cord to a
properly grounded outlet. Do not
remove the ground pin from power
cord.
with local building and electrical
codes. Connect power cord to a
properly grounded outlet. Do not
remove the ground pin from power
cord.
Wear safety glasses for eye
protection when installing or
servicing the opener or door.
protection when installing or
servicing the opener or door.