Wacom Intuos - 2 for Windows Manuale Utente

     Page  115

2.

  Move your Intuos2 Pen across the active area of the tablet; the screen cursor should 

move in the corresponding direction on your monitor.  Press the pen tip against the tablet surface.  
The status LED on the tablet should turn from orange to green.  Now, without applying pressure to the 
pen tip, press the side switch.  The status LED should again change from orange to green.  Turn the 
pen over and press the eraser against the surface of the tablet; the status LED should change from 
orange to green.  If not, you may have a defective pen or tablet.  See 

Intuos2 USB tablets require Windows 98, Me, 2000, or XP.  Many PCs that shipped with Windows 95 have 
the USB port disabled in the BIOS.  If you upgraded from Windows 95 to a newer version of Windows, 
verify that the USB ports are enabled in the BIOS and that all necessary system software has been 
installed.  Refer to your system documentation or contact your system manufacturer for information on 
enabling USB support for your computer.

Run the USB Ready utility located on the Wacom Tablet CD to check if your system is USB ready.

If your system is not USB ready, correctly configure your USB port and install the necessary USB system 
software, then restart your computer.  The N

EW

 H

ARDWARE

 F

OUND

 dialog should appear and you can 

continue with the Intuos2 installation.

Always be sure your tablet is plugged directly into your computer or into a powered USB hub.