Wacom Graphire - Bluetooth for Windows & Macintosh Manuale Utente
14
14
3. While the tablet is in discoverable mode, pair it to your computer. The following points provide a general
overview of the pairing process. For detailed instructions on pairing a Bluetooth device to your
computer, refer to the documentation that came with your operating system or Bluetooth support.
computer, refer to the documentation that came with your operating system or Bluetooth support.
•
Open the Bluetooth devices control panel. Some common access points to this control panel
include: the task bar, menu bar, control panel, or system preferences pane of your computer’s
operating system.
include: the task bar, menu bar, control panel, or system preferences pane of your computer’s
operating system.
•
From the Bluetooth devices control panel, start the process of adding a device. Common options to
do so are A
do so are A
DD
A
B
LUETOOTH
D
EVICE
, B
LUETOOTH
S
ETUP
, or S
ET
U
P
N
EW
D
EVICES
.
•
In the setup assistant that appears, carefully follow all directions to continue.
•
If prompted for the device type to set up, choose “mouse”.
•
When the tablet is discovered it will show up as WACOM P
EN
T
ABLET
. Select it and continue to
follow the prompts. If the tablet does not appear, you will need to refresh the assistant and again
press the tablet C
press the tablet C
ONNECT
button.
•
If prompted for an authentication code or passkey, select the “don’t use” or “no” option. The Graphire
Bluetooth pen tablet does not require passkey authentication.
Bluetooth pen tablet does not require passkey authentication.
•
If prompted for the device type services to add, choose the option for “tablet”. Otherwise choose
“mouse”.
“mouse”.
•
After the wireless tablet has been successfully paired to your computer it will appear as a connected
device in the Bluetooth devices control panel.
device in the Bluetooth devices control panel.
4. Close the Bluetooth devices control panel and check the connection. Place the pen on the tablet – you
should be able to move the screen cursor with the pen.
Once you have established a connection between your wireless tablet and the computer, they will
remember the connection – just as if you had connected a virtual cable between them. The tablet will
remember which computer it is connected to, and will reject all attempts by other computers to connect
to it.
remember the connection – just as if you had connected a virtual cable between them. The tablet will
remember which computer it is connected to, and will reject all attempts by other computers to connect
to it.
•
If the link is broken for more than two seconds (e.g., you shut down your computer, unplug your
USB-to-Bluetooth adapter or otherwise switch off your Bluetooth support, or move the tablet too far
away from the computer), the tablet will switch itself off.
USB-to-Bluetooth adapter or otherwise switch off your Bluetooth support, or move the tablet too far
away from the computer), the tablet will switch itself off.
•
When starting up your computer, wait until your operating system has completely loaded and then
push the tablet power button. The Bluetooth connection will automatically be reestablished.
push the tablet power button. The Bluetooth connection will automatically be reestablished.
•
If you again press the C
ONNECT
button, the virtual cable link will be broken and the tablet will once
again become discoverable by any Bluetooth enabled computer.
Important: Remember that the Graphire Bluetooth pen tablet driver software must be installed
before you will be able to work with full tablet functionality and features such as pressure-sensitivity
with the pen.
before you will be able to work with full tablet functionality and features such as pressure-sensitivity
with the pen.
5. If you have not already done so, install the pen tablet driver software. Insert the Wacom Pen Tablet
Driver CD into your computer’s CD-ROM drive, click on the I
NSTALL
T
ABLET
link, and follow the prompts
to install the driver software.