Wayne-Dalton Z-Wave WDSF-10 Manuale Utente
38
Resetting Thinkessentials
®
Use the following procedure to reset your
USB Z-Wave
®
Adapter to factory conditions.
WARNING: If your USB Z-Wave
®
Adapter and
ThinkEssentials® software are the Primary
Controller in a network, and you reset your
USB Z-Wave
®
Adapter, you will no longer
be able to add or remove modules from
your network without recreating the entire
network.
To reset the USB Z-Wave® Adapter:
1. Switch to the SeTTINGS tab, and then
click the ReSeT USB ADAPTeR To FACToRY
DeFAULTS link.
NoTe: If the USB Z-Wave
®
adapter is serving
as a secondary controller, remove it from the
network by clicking the ReCeIVe UPDATe FRoM
PRIMARY CoNTRoLLeR link and instructing the
Primary Controller to remove the USB Z-Wave
®
adapter. This may be referred to as ReMoVe
DeVICe, ReMoVe CoNTRoLLeR, eXCLUDe
DeVICe, or eXCLUDe CoNTRoLLeR.
NoTe: If you reset your Primary Controller before
removing all the Z-Wave
®
modules from your
network, you must reset each of the modules
(see “Removing modules from the network”,
page 13) before adding modules to the network
again.
again.
Factor
y Reset
on the SeTTINGS tab, click on the ReSeT
link.
link.