Stanton RM.416 Manuale Utente
connecting the RM.416
2.
connecting the RM.416
Before starting to connect the RM.416, please read the Important Safety Instructions page and study this setup diagram
(Figure 2.1). Make sure all faders are at "zero,” the Master Volume is turned all the way counterclockwise, and all devices are Off.
(Figure 2.1). Make sure all faders are at "zero,” the Master Volume is turned all the way counterclockwise, and all devices are Off.
2
Figure 2.1
Now, please follow these simple instructions:
1.
Connect all input sources.
2.
Connect your microphone and monitor headphones.
3.
Connect the stereo outputs to the power amplifier(s) and/or audio receivers such as tape decks.
4.
Plug your mixer and other devices into AC power.
5.
Connect your PC to the RM.416 via USB cable.
6.
Switch everything On in the following order:
- Audio input sources (such as turntables or CD players, etc).
- Mixer
- Amplifiers
- Audio input sources (such as turntables or CD players, etc).
- Mixer
- Amplifiers
note: When turning Off, always reverse this operation by turning Off amplifiers, then your mixer, and lastly any input devices.