Square SP4200 Manuale Utente

1. Pictured is the SP4" lamp ring
connector shown with the
large end of the flex rod inserted.

2. Small end of flex rod fits into
corner pocket on the softbox
tent.

3. With three rods inserted into
the ring and corners, fold the
SP 4" ring into the tent.

5. Insert the forth rod into the
pocket on the velcro strap.

6. Push the velcro strap into 
place just below the lip of the 
tent.

 

deal of force to flex into position.

Note: the rods take a good 

7. Now close the velcro flaps
as shown in the picture.

8. The SP 4" ring can now be
attached to the SP 160 flash unit.
DO NOT over tighten.

9. Next attach the inner diffusion
lens with the velcro straps.

10. Attach the outer diffusion
lens to velcro patches on 
the outer edges.

SAFETY PRECAUTIONS:

• Become thoroughly familiar with this product before use. Run 

• Wait until the bulb is completely cool before touching or 

through at least one practice assembly and breakdown before 

removing it.

you schedule a shoot.

• Never use the SP160 lamp outside in a wet environment.

• Make sure that the main voltage corresponds to that stated on 

• Never move the appliance by pulling the cord. Make sure the 

the SP160 lamp. Account for number of lamps in use.

cords do not come in contact with halogen bulb. Do not wind 

• Never leave the lighting unsupervised when in use. Keep 

the cord around the appliance.

children or incompetent persons away from lighting equipment.

• Stand the SP160 on a flat surface only to prevent toppling.

• If the lamp or the cord show sign of wear or damage, it should 

• Do not touch the metal parts on the lamp while in use, these 

be replaced or repaired by a qualified electrician before use.

metal parts will become very hot.

Softbox Assembly:

4. Next insert the fourth rod
into the SP 4" ring. Note: Keep
the velcro flaps at the ring
open to allow sufficient slack.

1. On/Off electric supply.
2. Variable flash buttons.
3. On/Off variable, model lamp.
4. On/Off flash ready beep.

5. Flash test.
6. Sync receptacle.
7. Safety fuse.
8. AC receptacle.

Specifications:

SP200 Lamp Head Operation:

Power Input : AC110-130 volt, 50 Hz
Flash Power : 200w (joule) in full
Guide No. : GN45
Color Temperature : 5600K
Flash-Tube Lifetime : over 8,000 typical flashing
Flash Power Setting : 1/32 to full
Recharge Time : 2 seconds in full
Flash Duration : 1/600 sec.; 1/1000 sec.
Slave Range : 35ft /10m
Lighting Range : 55 degree
Modeling Power : Halogen 100w
Synch Voltage : 5 volt
Fuse : 6A
Dimension : 4" x 7-1/2"
Weight : 1.8 Lb (800g) 

  9. Flash digital readout.
10. Remote button.
11. Flash ring.
12. Model lamp.