Roland BR-800 Manuale Utente

143

SD Cards that Can Be Used with the BR-800

Editing

Mastering

Using USB

Con

venient

Functions

Appendix

Quic

k Star

Getting Read

to Recor

Recor

ding/

Pla

ybac

Using

Eff

ects

Using

ythm

To prevent the removed screw from being lost, use a

Phillips (+) screwdriver to attach it in the location

shown in the illustration below.

fig.CardSlot03.eps

■

Inserting an SD card

Insert the SD card so that its contacts are facing upward.

fig.InsCard.eps

■

Removing an SD card

Gently press the SD card inward, and then release your
finger.

The SD card will pop out slightly, allowing you to remove
it.

■

The SD card write protect feature
(LOCK)

The contents of the SD card can be protected by write
protecting it. To write protect a card, slide the write protect
switch on the side of the SD card to the “LOCK” position.
Unlock write protect to delete data on the SD card.

fig.SD_SW-e.eps

• When turning the unit upside-down, get a bunch

of newspapers or magazines, and place them
under the four corners or at both ends to prevent
damage to the buttons and controls. Also, you
should try to orient the unit so no buttons or
controls get damaged.

• When turning the unit upside-down, handle with

care to avoid dropping it, or allowing it to fall or
tip over.

• Keep any screws or card cover you may remove

and the included SD card in a safe place out of
children’s reach, so there is no chance of them
being swallowed accidentally.

• Carefully insert the SD card all the way in—until

it is firmly in place.

• Do not touch the contacts of the SD card or allow

them to get dirty.

• Never insert or remove an SD card while this

unit’s power is on. Doing so may corrupt the
unit’s data or the data on the SD card.

Writing allowed

Writing prohibited (LOCK)

BR800_e.book 143 ページ２０１０年３月２日　火曜日　午後６時４０分