Harbor Freight Tools 12 Ton Steel Jack Stands Manuale Del Prodotto
Page 2
For technical questions, please call 1-800-444-3353.
Item 61599
IMPORTANT SAFETY INFORMATION
WARNING Read all safety warnings and instructions.
Failure to heed these markings may result in personal injury and/or property damage.
Save all warnings and instructions for future reference.
The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense
and caution are factors which cannot be built into this product, but must be supplied by the operator.
1.
Study, understand, and follow all instructions
before operating this device.
2.
Do not exceed rated capacity.
Be aware of dynamic loading!
Sudden load movement may briefly create
excess load causing product failure.
3.
Use only on hard, level surfaces.
4.
Center load on saddle.
5.
Use as matched pair to support
one end of a vehicle only.
6.
Wear ANSI-approved safety goggles and
heavy-duty work gloves during use.
7.
Do not use for aircraft purposes.
8.
Support vehicle only at manufacturer-
recommended locations.
9.
Inspect before every use;
do not use if parts loose or damaged.
10.
Examine Jack Stands for cracks or damage
before each use. Do not use if even a minor crack,
bend or other damage/deformation appears.
Discard Jack Stand if damaged or deformed.
11.
Keep work area clean.
Cluttered areas invite injuries.
12.
Observe work area conditions.
Keep work area well lighted.
13.
Keep children away. Children must
never be allowed in the work area.
14. When not in use, tools must be stored
in a dry location to inhibit rust.
15. Use as intended only.
16. Do not wear loose clothing or jewelry as they
can be caught in moving parts. Protective,
electrically non-conductive clothes and non-skid
footwear are recommended when working. Wear
restrictive hair covering to contain long hair.
17.
Maintain tools with care.
Keep tools clean for better and safer performance.
18.
Stay alert. Watch what you are doing, use common
sense. Do not operate any tool when you are tired.
19.
Do not operate tool if under the influence
of alcohol or drugs. Read warning labels
on prescriptions to determine if your judgment
or reflexes are impaired while taking drugs.
If there is any doubt, do not operate the tool.
Assembly
1. Take a
Post and face the ratchet edge toward
the front of the
Base. The Pawl is on the front.
2. Lift the
Handle and lower the Post into the
Base. Make sure it is completely lowered.
CAUTION! Be alert to pinching danger
when lowering the
Post.
3. On the opposite side of the
Handle there is a tab on
the
Base. Using a small punch and hammer (sold
separately), bend the tab in. Bend the tab in enough
to keep the
Post from coming out of the Base.
WARNING! Before using the Jack Stands, make sure
the
Post cannot be pulled up and out of the Base.
4. Repeat Steps 1 through 3 above
with the other Jack Stand.
Tab
Post
Base
Pawl
(not shown)
Handle