Znyx Networks bh5700 Manuale Utente

are supported.

enable;

The enable statement turns on stacking that has been previously configured.    This statement 
cannot be made until configuration is complete.

disable;

 The disable statement turns off stacking.  Before disabling stacking, all Ethernet Switch Blade 
daemons must be stopped, and the VLAN configurations must be torn down using zconfig.

 

zstack stack0: ppa0 local

 zstack stack1: ppa1 local

 zstack stack0: zre0..23, zre48..49 = zre0..25

 zstack stack1: zre24..47, zre50..51 = zre0..25

 zstack stack0: trunk0 = zre26..27

 zstack stack1: trunk0 = zre26..27

 zstack stack0: stack1 = trunk0;

 zstack stack1: stack0 = trunk0;

 zstack enable

Wild card characters can be included to simplify the process of creating larger, more complex 
configurations. Wild card characters for zconfig include: 

,   (comma)

Use for creating lists

..  (dot-dot)

Specifies an inclusive range

Below are some examples for the correct usage of the comma (,) and dot-dot (..). Each line below 
produces the same results:

stack0: zre4..7 = zre0, zre1, zre2, zre3;

stack0: zre4, zre5..7 = zre0..3;

stack0: zre4..7 = zre0, zre1..3;

stack0: zre4, zre5..7 = zre0..1, zre2..3;

The stack may also be in list form in the Stack Configuration command in similar fashion to the 

Ethernet Switch Blade User's Guide

release  3.2.2j

page  256