Znyx Networks bh5700 Manuale Utente

other words there is a unique vrid to ifname associated with the 

–i option.

-s

Toggle preemption mode (Enabled by default).  Preemption 

means that a Master switch will go to Backup if a current Backup 

has higher priority.

-M

Become MASTER when priority is equal.  Be sure it is only 

set on one host or the switches will oscillate. Must set –B 

option on other hosts (requires preemption mode ! -s)

-B

Become BACKUP when priority is equal.  See -M option 

-S <script>

script to be called when state change occurs.

-a <auth> (not yet implemented) set the authentication type 
auth=(none|pass/hexkey|ah/hexkey) hexkey=0x[0-9a-fA-F]+

-p <prio> Set the priority of this host in the virtual server 

(default is 100)

-f <piddir>

specify the directory where the pid file is 

stored (default is /var/run)

-c <conf> Configuration read from conf file (required when 

managing multiple Virtual Routers).  The contents of the conf 
file are lines of command line options.  Each line represents a 

Virtual Router.  Parameters given on the command line apply to 
all Virtual Routers defined by the conf file.  So for example, if 

the command line reads:

vrrpd –d 50 –c vrrpd.conf

And the vrrpd.conf file contains:

-v 1 –i zhp0 –I zhp3 10.0.0.42

-v 2 –i zhp1 –I zhp3 11.0.0.42

vrrpd would be started controlling two Virtual Routers; one for 
10.0.0.42 and the other for 11.0.0.42.  They would both get a –d 

50 option.

-d <delay> Set the advertisement interval.  Default is 1 second. 
By default time is specified in seconds.  If the delay value ends 

in a lower case ‘m’ the time is specified in milliseconds.  The 
millisecond specification results in a proprietary use of the 

VRRP Adver Int field.

-m <address>

Change the virtual MAC address from 

00:00:5E:00:01:<vid> to the provided addr.  The addr should be 

input as 6 two digit hex numbers that are colon delimited with no 

Ethernet Switch Blade User's Guide

release  3.2.2j

page  270