Znyx Networks bh5700 Manuale Utente

tag are given the VLAN tag with the VID number 1, enter:

zre1=untag1;

If port 0 is also a member of VLAN 100, packets for VLAN 100 are sent from this port with a 
VLAN tag as part of their header.

In the next example, the switch ports 10, 11, and trunk 2 are configured as untagged members of 
VLAN 100.

zre10,zre11,zrl2=untag100;

This statement is equivalent to the following three lines:

zre10=untag100;

zre11=untag100;

zrl2=untag100;

In the examples above, since port interfaces can only be untagged for one VLAN group, zre1 
cannot also be untagged for VLAN 100. A port or trunk can be a member of multiple VLANs but 
can only be designated untagged on one VLAN.

Wild card characters can be included to simplify the process of creating larger, more complex 
configurations. Wild card characters for zconfig include: 

,   (comma)

Use for creating lists

..  (dot-dot)

Specifies an inclusive range

+  (plus) Specifies auto-incrementing

Below are some examples for the correct usage of the comma (,) and dot-dot (..). Each line below 
produces the same results:

zhp0: vlan1 = zre1, zre2, zre3, zre4;

zhp0: vlan1 = zre1..4;

zhp0: vlan1 = zre1, zre2..4;

zhp0: vlan1 = zre1..2, zre3..4;

The following examples create multiple VLAN groups using a single statement. A list of network 
interface names are followed by a colon (:) and a list of VLAN actions which are followed by an 
equal sign (=) and a port list. Each VLAN group is created in turn, along with the corresponding 

Ethernet Switch Blade User's Guide

release  3.2.2j

page  279